1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

90 crx Axle Problem

Discussion in 'Civic and CRX - EF' started by Bound2none, Sep 17, 2006.

  1. Bound2none

    Bound2none New Member

    Messages:
    2
    Likes Received:
    0
    Joined:
    Sep 17, 2006
    Ok guys, im new to hondas and especially this forum. Figure ill give it a shot.

    I just bought a 90 crx with b18b swap from a 90-91 teg with a teg tranny. The passanger side axle is binding and seems way too long. The axle is a 93' teg axle. I bought the car like this. I dont know what hubs it has (id guess stock). Im not sure if its a si, hf. Its a rebuilder for sure. If you know what kind of axles I might need, please tell me!!

    I read a post that said something about the dust caps? Not sure.
     
  2. bb16hatch

    bb16hatch Junior Member

    Messages:
    59
    Likes Received:
    0
    Joined:
    Aug 5, 2005
    if you have hcp mounts try a 87 teg
     
  3. Bound2none

    Bound2none New Member

    Messages:
    2
    Likes Received:
    0
    Joined:
    Sep 17, 2006
    hcp?

    what are hcp hubs??
     
  4. formby

    formby learning in progress

    Messages:
    5,735
    Likes Received:
    23
    Joined:
    Feb 19, 2003
    you will need the same axles that go with the half shaft....if the engine was operating when you go it then just replace the axles and the axle seals that go on the tranny..

    make sure to push the axle in all the way
     
Verification:
Draft saved Draft deleted

Share This Page