I finished putting my new clutch and flywheel in.
I get all the tools put up, and drive around the block once.
Everythings fine.
I leave a couple of hours later, and when I get to the end of the street it happens.
The car will go forward VERY slowly.
Tow the car home. Look under the hood only to see the passenger side axle has popped out of the tranny past the splines, about 2 1/2in.
When I tried to push it in, it won't go. Pull axle out, everything looks fine.
Get wood, hammer axle into tranny.
Drive car around block, and after a minute of driving it pops out again!
What is going on here?
Why won't the axle stay in the tranny?
I have GSR tranny,half shaft,axles in '97' Civic.
HELP
I get all the tools put up, and drive around the block once.
Everythings fine.
I leave a couple of hours later, and when I get to the end of the street it happens.
The car will go forward VERY slowly.
Tow the car home. Look under the hood only to see the passenger side axle has popped out of the tranny past the splines, about 2 1/2in.
When I tried to push it in, it won't go. Pull axle out, everything looks fine.
Get wood, hammer axle into tranny.
Drive car around block, and after a minute of driving it pops out again!
What is going on here?
Why won't the axle stay in the tranny?
I have GSR tranny,half shaft,axles in '97' Civic.
HELP