B16A with Eagle B18 3.504 crank what pistons and rods do i need?

[aRandy]

I was offered an Eagle B18 3.504 stroke crank 1835041772.
The journal width .945 and Diam 1.722 are the same as those in a B16A so i figured i make a new short blok for my daily driver who puffs allot of smoke these days

The thing is i don't really know what rod and piston combo i could use this with it to get the best bang for my buck.
The car drives on regular pump gas which is octane RON 95.

Is there a good reference somewhere which i can use, i searched but didn't find something usefull.

 

[aRandy]

Before i forget the head i use is a B18C1 with B16B valvetrain and cams.

I tried doing something with the calculator but i can't figure it out yet.
Honda B-Series Compression Calculator by ZealAutowerks

 

[josh_crewdson@y]

Custom length rods

 

[CAFROG]

Stroked motor is custom (like stated above)

I cannot lead you anywhere specific but I suggest you contact a reputable company who manufactures rods and give them the specs.

 

[aRandy]

I checked the numbers on the crank but it isn't a stroked crank as the guy claims it's a std B18 stroke. So the whole deal is off i'll look for something more cost effective.

 

[phunky.buddha]

3.504 inches = 89mm

So in a B18/B20 block use standard pistons and rods.