1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Please Help!!!! b16a head b16a block w B18b crank, eagle rods, and je 83mm pistons

Discussion in 'Engine Building' started by KME99Si, Nov 2, 2008.

  1. KME99Si

    KME99Si New Member

    Messages:
    2
    Likes Received:
    0
    Joined:
    Nov 2, 2008
    :confused:Hey guys im pretty new to the honda scene since i have been messing with 240's for a couple years now i picked up a 99 Si that is cherry, but spun a bearing on the way home its an r-title and i paid 3100 for it...so i was going to keep my stock block but my question is will it fit a ls crank, je pistons (83mm, yes i know it will be bored 2mm over stock) and eagle rods (all ment for the b18b or b18a) should all of this fit with proper stroke etc? i need to know asap because the guy who has the crank, pistons and rods isnt going to hold on to them forever so if anyone could give me some quick input it would be greatly appreciated thank you very much!! or if anyone would like to contact me directly with knowledge about this it would be greatly appreciated. contact kevin at 717-368-4418 anytime!!!
    Thanks
    Kevin:confused:
     
  2. KME99Si

    KME99Si New Member

    Messages:
    2
    Likes Received:
    0
    Joined:
    Nov 2, 2008
    Bump....any input????
     
Verification:
Draft saved Draft deleted

Share This Page