78civic
Junior Member
After reading on Endynes' site of the filling in (welding) in the chamber to raise compression.
What do you guys think of removing the seats by heating the head enough to loosen them, then welding up, then heat treating back to spec after re-installing the seats.
Just a thought. Probably cheaper to have custom rods/pistons and a block guard to raise comp instead.
E
What do you guys think of removing the seats by heating the head enough to loosen them, then welding up, then heat treating back to spec after re-installing the seats.
Just a thought. Probably cheaper to have custom rods/pistons and a block guard to raise comp instead.
E