i have a obd0 b18a with ecu and tranny, i already have the motor mounts , but i was looking at the 1.5 motor still in the hatch and theres no injector plugs and it looks like its carberated. Do i have to get a crx si harness or whats the deal ,also what do i need to make the axles fit?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
b18a into 90 hatch dx
- Thread starter vtecdaddy
- Start date
- Replies 3
- Views 863
We may earn a small commission from affiliate links and paid advertisements. Terms
tylonalsnifnfool
Senior Member
You've got DPFI (dual port fuel injection). My old CRX was a Dx. After my first attempt at a MPFI conversion I gave up. It can be done but it takes alot of knowledge.
im not big into wiring , so if i get a 88-91 hatch si or crx si everything will jus plug up right????Quoted post[/post]]
You've got DPFI (dual port fuel injection). My old CRX was a Dx. After my first attempt at a MPFI conversion I gave up. It can be done but it takes alot of knowledge.
brian11to1
Senior Member
Quoted post[/post]]
im not big into wiring , so if i get a 88-91 hatch si or crx si everything will jus plug up right????Quoted post[/post]]
You've got DPFI (dual port fuel injection). My old CRX was a Dx. After my first attempt at a MPFI conversion I gave up. It can be done but it takes alot of knowledge.
no.
use your stock DX harness, wire for MPFI and extend the TPS 6" as well as switch the two outter wires.