1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

b20 VTEC hood?

Discussion in 'HYBRID -> ED-EF / DA' started by b16hatch, Apr 15, 2005.

  1. b16hatch

    b16hatch Member

    Messages:
    51
    Likes Received:
    0
    Joined:
    Mar 21, 2005
    Ok i picked up my car today with the fresh b20 VTEC install. The proplem was my car is so low my drive axles were a angle , so they raised the whole thing about a inch and a half , now the axles are nice and straight. Anyway my hood will no longer latch , so i just took the cf hood off. Anyone know where i can get like a 3 inch cowl hood with the cowl about 30 inches wide?
     
  2. civicious

    civicious FüK-VTEC VIP

    Messages:
    9,855
    Likes Received:
    629
    Joined:
    Jun 15, 2003
    Location:
    Houston, TX
    Don't get a cowl hood, dude...get an SiR hood. It'll clear the motor, and look a hellovalot better than a stupid cowl.
     
  3. b16hatch

    b16hatch Member

    Messages:
    51
    Likes Received:
    0
    Joined:
    Mar 21, 2005
    i thought u need to get the bumbers and fenders and everythink to make a sir hood fit
     
  4. civicious

    civicious FüK-VTEC VIP

    Messages:
    9,855
    Likes Received:
    629
    Joined:
    Jun 15, 2003
    Location:
    Houston, TX
    VIS makes one that's the SiR style (goes up in the middle instead of down) that'll fit on a USDM. I think ProStreetOnline.com has them
     
Verification:
Draft saved Draft deleted

Share This Page