Aight im a little stuck on what are good pistons. I did the whole top of my engine and now its time for the rest. I have skunk2 stage 2 cams, skunk2 valves, retainers, springs and all that good stuff. A 0.6 metal head gasket. skunk2 intake manifold, ingen cold air intake. dc headers, tanabe cat back, pulleys, aem fuel rails, regulator, 660 injectors, centerforce dual friction clutch, hondata ecu. And some other little stuff. Im getting the aem computer, the one that hooks up to your lab top. This is more of an every weekend driver. So my questions are
What pistons should i get and what compression?
Should I bore and sleeve?
What should i bore it to?
Port and polish, yes or no?
Also what rods should i get with the pistons?
Then should i go for the crank?
Just a few questions that i need some suggestions on. Thanx alot
What pistons should i get and what compression?
Should I bore and sleeve?
What should i bore it to?
Port and polish, yes or no?
Also what rods should i get with the pistons?
Then should i go for the crank?
Just a few questions that i need some suggestions on. Thanx alot