i just swapped a 93 LS motor into my rex and did an OBD1 conversion, it starts and runs fine. i have a couple problems though.. my tach, fuel gauge, and temp gauge aren't working, any suggestions?
i just swapped a 93 LS motor into my rex and did an OBD1 conversion, it starts and runs fine. i have a couple problems though.. my tach, fuel gauge, and temp gauge aren't working, any suggestions?
the plugs to the back of the cluster are fine, as well as the plugs by the fuse box... could not having a sensor hooked up cause it? i only have one that isn't connected and its this:
does anyone know what its for? the book for the rex says block thermosensor but the book for the integra doesn't have that sensor listed...
i did an obd0 to obd1 conversion so i am using the obd1 distributor... which fuse powers the cluster, or which fuse did you replace? i thought there was only one fuse that went to the cluster and it was for the lights
yeah i found the problem, i tried turning on my blinkers and they didnt work, turns out that fuse was blown... i feel lame but now everything works, thanks for the input guys
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.