hatukazi
ambitious...but rubbish
ok, so I believed the person I traded shells with when he said OBD2 injector clips will fit OBD1 injectors.
silly me.
it is a 90 civic lx that ran fine with his SiRII swap in it, guages converted to GSR cluster w/ elec speed sensor. and has a conversion harness to OBD1.
at some point I was going to re-wire his job anyway because it was wired with speaker wire.
so before I start cutting up my 95 EX harness, I was wondering if someone could point me towards a write up that might tell me how to just run wires all the way down to the ECU plugs on the other side of the firewall.
or at the very least just enough to run my injector wires back to the ECU plugs.
the engine I will be using is a D16Z6 and a stock P28 out of my del sol.
silly me.
it is a 90 civic lx that ran fine with his SiRII swap in it, guages converted to GSR cluster w/ elec speed sensor. and has a conversion harness to OBD1.
at some point I was going to re-wire his job anyway because it was wired with speaker wire.
so before I start cutting up my 95 EX harness, I was wondering if someone could point me towards a write up that might tell me how to just run wires all the way down to the ECU plugs on the other side of the firewall.
or at the very least just enough to run my injector wires back to the ECU plugs.
the engine I will be using is a D16Z6 and a stock P28 out of my del sol.