i was wondering if anyone has any advice for a newbie to the world of swapping. I have a 91 CRX dx and a 89 CRX si. The D15 in the dx is dead and the body & frame on the si are dead. I'm in the process of putting the D16 into the dx. the D15 is disconnected with the exception of the roll pin in the shift linkage. I plan on dropping the D16 block, tranny and drive axles into the 91. I'm also gonna change out the ECU, harness, seats and possibly the door panels. I also picked a slightly used 4-2-1 header Ractive stainless header to slap in as well. Is there anything strange that I might be missing in the swap? Right now the only info I have to go off of is the helm's manual and a how-to list I downloaded a few days ago. The how-to list says to use the existing harness, but I'm not sure about that. Any ideas? Thanx in advance for the help