1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Drive shaft question

Discussion in 'HYBRID -> EG-EK / DC' started by richievti, Jul 16, 2003.

  1. richievti

    richievti Junior Member

    Messages:
    1
    Likes Received:
    0
    Joined:
    Jul 16, 2003
    can i use my 1.5 vtec e drive shafts when swapping with 1.6 b16a2,

    Please could anyone help.

    Thanks Richie
     
  2. E_SolSi

    E_SolSi Member of the 20 nut club Moderator VIP

    Messages:
    30,036
    Likes Received:
    3,970
    Joined:
    Sep 28, 2002
    Location:
    CT
    no
    you need B series axles
     
  3. bgcustoms

    bgcustoms New Member

    Messages:
    8
    Likes Received:
    0
    Joined:
    Dec 4, 2007
    b16 axles 93 civic


    if i was putting a b16 in my 93 civic si, i would just need b-series axles and not the intermediate shaft right? ( I just need b-series axles nothing else?)
     
  4. UNDR8D

    UNDR8D ...has a job!

    Messages:
    3,939
    Likes Received:
    115
    Joined:
    Sep 13, 2007
    Location:
    8OH!5
    No, you need the intermediate shaft. B series axles are approximately the same length whereas the D axles are long (driver side) and short (passenger side), so you need the int. shaft to span the back of the block. A simple search would have yielded the answer to this question though.
     
  5. bgcustoms

    bgcustoms New Member

    Messages:
    8
    Likes Received:
    0
    Joined:
    Dec 4, 2007

    ok, thanks for the info. Does the axle that goes into the int. shaft have a lock ring on it also?
     
Verification:
Draft saved Draft deleted

Share This Page