Droping in a ZC, need help

We may earn a small commission from affiliate links and paid advertisements. Terms

d16a6civichatch

d16a6civichatch

New Member
i am going to put a doch zc motor in my car and i already have my wire harness set for MPFI.but want to make sure i dont have to mess with the harness any more.... can any one give me a good web site that helps with puting in a ZC motor.? thanks
 
If you have your wiring harness set for mpfi already than the only change you will need to make is at the distributor. The sohc mpfi harness has a single round plug at the distributor and the dohc has a rectangular one at the dizzy and than a 2 wire over at the cam sensor. You can use the stock dx dizzy connector and than run the extra 2 wires from the ecu to the cam sensor on the exhaust cam. I don't have the link that I used to do my zc swap but check around this site or at www.thezcr.com Good luck
 
You must log in or register to reply here.
Back
Top