CrazyAzn
Senior Member
well heres the deal, i was wondering how much you could mill the head on a gsr/ poormans itr and still be okay.
my current set up is usdm b16 pistions, block decked .003 with the head milled about .013.
i acquired a built head that was milled about .035-.040, would this be okay on my motor??? im not fully sure if ne one has put a milled head on this type of set up. . . has ne one done this before?
i also know i should clay the motor when this is done, but i was just wondering if ne one had any input on this.
whats the normal amount people mill heads?
thanks
my current set up is usdm b16 pistions, block decked .003 with the head milled about .013.
i acquired a built head that was milled about .035-.040, would this be okay on my motor??? im not fully sure if ne one has put a milled head on this type of set up. . . has ne one done this before?
i also know i should clay the motor when this is done, but i was just wondering if ne one had any input on this.
whats the normal amount people mill heads?
thanks