We may earn a small commission from affiliate links and paid advertisements. Terms
Originally posted by NyQuiL_AcCoRD@Sep 4 2004, 07:29 PM
I just finish swapping a H22A into my 1995 Accord too. The only mounts I had to replace were the front mount, and the left-side mount. I needed to replace the left-side mount, so the transmission would sit properly. Also, depending on the condiition of your mounts. You may need to replace all of them.
Also, your car is OBD1, and if your H22A (JDM) motor is OBD1 (92-96), then you'll be fine.
[post=386218]Quoted post[/post]
Originally posted by dohcvtec_accord@Sep 7 2004, 10:02 AM
I did this swap, and didn't replace any mounts. The driver's side mount needs to be modified to make it work, but that's about it.
[post=386914]Quoted post[/post]
Originally posted by tab@Sep 7 2004, 08:38 PM
That's the mount I was talking about. I'm pretty sure you could just use a 90-93 F22 driver's side mount. There's a bit of difference between the F22A and F22B1, including that mount.
[post=387292]Quoted post[/post]
Originally posted by dohcvtec_accord+Sep 8 2004, 08:48 AM-->@Sep 7 2004, 08:38 PM
That's the mount I was talking about. I'm pretty sure you could just use a 90-93 F22 driver's side mount. There's a bit of difference between the F22A and F22B1, including that mount.
[post=387292]Quoted post[/post]
Wow, wish I had known that when I did my swap. I also wish that I had read your post thoroughly before opening my yap.
[post=387396]Quoted post[/post]