We may earn a small commission from affiliate links and paid advertisements. Terms
Originally posted by sihatchback_RL@May 30 2005, 11:50 PM
pretty darn easy, about a ful day works. how long are you going to keep that motor? if it's shit hell, leave it save yourself some money.
[post=505488]Quoted post[/post]
Originally posted by hmtcrxsir+May 31 2005, 05:26 AM-->It's definitely not a beginner job... leave it to a pro.Alot of guys at HondaTech and HMT discourage me on changing the bearings since im a beginner and all. But it's probably much easier than changing the whole engine itself. They told me that the hard part is measuring the clearance of the bearings. So if you can give me any info or any advice. I would greatly apprepicate it![post=505562]Quoted post[/post]
Originally posted by hmtcrxsir@May 31 2005, 05:26 AM
Also I am not sure if it's really my bearings or not. Well basically my engine was knocking pretty hard after oil starvartion. The knock got louder as rpm increases and also notice in loss of power. It's more of a rattling noise than a knock.[post=505562]Quoted post[/post]
I would take the engine apart first to see what's going on before I spent $200-300 at Honda for new bearings... plus I would want to see which bearings I needed before spending money on a batch that could very well be all the wrong size.
Originally posted by hmtcrxsir@May 31 2005, 05:26 AM
I'm also concerned that i might have scratch the crank.
[post=505562]Quoted post[/post]
If you did, then you need it machined, polished, then spec'd out for bearings that can't be found by using your service manual anymore- your crank and block's letter/number codes won't mean a damn thing after you polish the crank.
hmtcrxsir@May 31 2005, 11:19 AM
so whats the difference between crank, main, rod bearings? I'm confused? And where are each bearings located at? Wish i got a helm manual. It would be so much easier.
[post=505659]Quoted post[/post]