Just put a skunk 2 intake on my B18C
Now it idles way to high and it wavers, but if I take off the intake and stick my finger into a manufactured hole in the inside of the throttle body towards the rear side of the engine, right before the butterfly it works great.
There is quite a bit of suction in that hole.
I am throwing a code for the IAT sensor as well.
Do I have a seal out of place?
I’m not sure what might be wrong here.
Now it idles way to high and it wavers, but if I take off the intake and stick my finger into a manufactured hole in the inside of the throttle body towards the rear side of the engine, right before the butterfly it works great.
There is quite a bit of suction in that hole.
I am throwing a code for the IAT sensor as well.
Do I have a seal out of place?
I’m not sure what might be wrong here.