jdm_civic_sirII
Member
What would I need to do to put ITR pistons into my b20? My new to this stuff so bare with me.
We may earn a small commission from affiliate links and paid advertisements. Terms
Originally posted by SpodaB1@Aug 4 2004, 08:54 PM
Overbore ITR pistosn.
B20 Bore = 84mm
B16/LS/GSR/ITR bore = 81mm
[post=372727]Quoted post[/post]
Originally posted by handlebarsfsr@Aug 4 2004, 11:46 PM
they will fit.. you might have a little piston ring gap issue, and possibly a low compression psi, but otherwise it sounds like a great idea.
[post=372818]Quoted post[/post]
Originally posted by JDMilan@Aug 4 2004, 11:12 PM
lol,. they don't...........
get some 84mm pistons mang.
[post=372791]Quoted post[/post]
Originally posted by hybrid89+Aug 5 2004, 12:09 AM-->handlebarsfsr@Aug 4 2004, 11:46 PM
they will fit.. you might have a little piston ring gap issue, and possibly a low compression psi, but otherwise it sounds like a great idea.
[post=372818]Quoted post[/post]
tell me you kidding?
[post=372833]Quoted post[/post]
Originally posted by StyleTEG@Aug 5 2004, 03:29 PM
Just use JB weld to make some extra extra thick rings.
[post=373085]Quoted post[/post]
Originally posted by shaneb+Aug 5 2004, 02:38 AM-->JDMilan@Aug 4 2004, 11:12 PM
lol,. they don't...........
get some 84mm pistons mang.
[post=372791]Quoted post[/post]
The motor wont start i put some itr pistons in a ls block that was 83mm and the pistons was stock size 81 just to see if it was posible ..and the mortor never did start.....but i did here the pistons slaping around on crank over....that was cool
[post=372861]Quoted post[/post]