daloco1
New Member
I just finished a h22 auto swap in a ek coupe, it ran great on the ex computer with the harness i made, then i re-did the harness for a jdm p72 AT computer, everything is wired correctly except the 1st gear position because i dont have the integra shifter and cable yet. just tonight i pulled the harness to verify all connections, grounds, powers were good and rang each ecu pin to the coresponding plug pin, as well as a visual inspection. everything is good. changed the icm as well. i pulled a plug and grounded it to check for spark, good. also the injectors are pulsing, fuel pump is running, and the only code im flashing is a vtec pressure switch 22(dont understand that either as it is a jdm ecu and should not be looking for that) but i just wont fire up. there are a few wires left over that were not needed like secondary o2 3wire iacv and a white/red wire that seems to be going to the intelock control. im thinking that wire is the problem. any input would be great. sorry is so wordy, just wanted to save time and skip the simple "did you check the ground" type of responces