Can anyone tell me if $ 700 is a good price for a 1993 JDM B16A2 SiR II Head, intake, wire harness, etc. And also is this a good head to do an Ls/vtec setup for a 95 Integra
yeah, b16 heads are a dime a dozen, the gsr units which make a smaller/tighter combustion chamber run a little higher like 500-600, I have seen a good amount of B16 heads selling for 300. Is this a stock intake that comes with it?? If it is, won't you be upgrading it anyway "unless your a FFsquad JDM freak", so you won't need that.
A lot of that stuff needs to be thrown out. The head gasket is worthless except for claying your new engine, the head bolts are dead. I wouldn't pay $700 for it. I bought an entire B16A (first gen) for $650. All it needed was an OBD1 distro because your LS injectors will work fine.
yeah that true i kinda have that feeling, but i talked to some people that said its a fair price for a JDM head. I havent found a complete one yet for less than that. they are all stripped down and want more . I mean the shit that i dont need i can still make a buc on ebay for them, so i make a bit of money back
that price is a little steep for me. i can get a b16 head for 550, but i would have to wait two weeks. then again i would buy it for 650 also, because i dont like waiting for shit.
What kinda price difference would you expect between a USDM b16A2 complete head, intake manifold, injectors, etc versus the same setup of a JDM b16a2 complete head?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.