hey guys, i was just wondering if you guys could answer me a couple of questions about my swap.
by the way, am doing this to a 95 cx.
1st i already dropped in the b16 and connected all lines cept for one because i cant seem to find the place where it goes. my uncle told me that it is a vacuum line and that i should just cap it off and it will be ok, is this true?
2nd i have to add the vtec wires since i have the cx, i already did the vtec solenoid, but the evap purge solenoid is a red wire that goes in pin A20, but my wiring harness already has a red wire that runs to pin A20, does this mean i have evap purge solenoid connected already, and also that i dont have to connect the evap purge power?
and last, can u guys tell me what wire color is
the 12V dash light
12V ingnition switch (+)
and can u tell me where the coil or electronic ignition on my car is? am trying to install a autometer tach
thanx
by the way, am doing this to a 95 cx.
1st i already dropped in the b16 and connected all lines cept for one because i cant seem to find the place where it goes. my uncle told me that it is a vacuum line and that i should just cap it off and it will be ok, is this true?
2nd i have to add the vtec wires since i have the cx, i already did the vtec solenoid, but the evap purge solenoid is a red wire that goes in pin A20, but my wiring harness already has a red wire that runs to pin A20, does this mean i have evap purge solenoid connected already, and also that i dont have to connect the evap purge power?
and last, can u guys tell me what wire color is
the 12V dash light
12V ingnition switch (+)
and can u tell me where the coil or electronic ignition on my car is? am trying to install a autometer tach
thanx