integra89vtec
Junior Member
Hello Guys:
I have swap a b16a on my 1989 Integra, I have rewired all my ECU`s pins and everything work fine, but the problem is that I have changed the stock double O2 manifold for a single O2 header wich I put together both O2 wires and connect them to the single O2 but now when I try to put a Rich & Lean gauge it does not function ,what could it be the problem? you might thing getting both wires together will affect something?
below is a diagram that explain what I did? from the oxygen sensor come one wire that I splited into two wires that one goes to the C8 pin and the other goes to the C16 pin on the ECU
O2------------/----C8
\----C16
I have swap a b16a on my 1989 Integra, I have rewired all my ECU`s pins and everything work fine, but the problem is that I have changed the stock double O2 manifold for a single O2 header wich I put together both O2 wires and connect them to the single O2 but now when I try to put a Rich & Lean gauge it does not function ,what could it be the problem? you might thing getting both wires together will affect something?
below is a diagram that explain what I did? from the oxygen sensor come one wire that I splited into two wires that one goes to the C8 pin and the other goes to the C16 pin on the ECU
O2------------/----C8
\----C16