Well, as long as your all plugged up, I don't know why it wouldn't run?
I was serious...
sleepercivic69 said:
obd0 inj, obd0 dizzy and an obd0 ecu(pr3)
.
You can run your engine with this setup
ok. It won't run best, but it will start and run fine... A P28 ecu will run best, which is designed for the engine.
Just make sure of just a few things-
-Map sensor is moved off the firewall onto the top of the throttle body
-
4 wire o2 sensor is wired/plugged in.*
-
VTEC is wired in(just 2 wires.)*
*When you switch over to OBD-1(P28 ecu), buy the
Boomslang Harness, and it will come
pre-wired with the extra 8 wires- 4 for o2, 2 for vtec, 1 for IAB and 1 for knock.
IAB and Knock sensors are
NOT used on D series.
All you'll need to do when you get the new ECU and Harness in, is just plug and play.
You'll need to remove the 6 wires you ran for the obd0 ecu, and slip the new wires into place.