qtmac_mien
Senior Member
is there a easy way to take off a b series pully while the motor is in the car?? i noe one easy way is to use a air gun, but i dont have one and the whole motor is already in the car. any ideas?
We may earn a small commission from affiliate links and paid advertisements. Terms
Originally posted by qtmac_mien@Jan 19 2005, 06:41 PM
do you noe where i can buy that special tool?
[post=448281]Quoted post[/post]
Originally posted by qtmac_mien@Jan 19 2005, 06:41 PM
do you noe where i can buy that special tool?
[post=448281]Quoted post[/post]
Originally posted by hcivic.com@Jan 19 2005, 11:38 PM
its called put the car in gear and have a friend hold the brakes then get a good sized breaker bar
[post=448443]Quoted post[/post]
Originally posted by B16RacerN2NR+Jan 19 2005, 10:40 PM-->hcivic.com@Jan 19 2005, 11:38 PM
its called put the car in gear and have a friend hold the brakes then get a good sized breaker bar
[post=448443]Quoted post[/post]
have someone hold the flywheel with a pry bar, then break the pulley nut loose
[post=448469]Quoted post[/post]
Originally posted by hcivic.com+Jan 20 2005, 01:01 AM-->Originally posted by B16RacerN2NR@Jan 19 2005, 10:40 PM
hcivic.com@Jan 19 2005, 11:38 PM
its called put the car in gear and have a friend hold the brakes then get a good sized breaker bar
[post=448443]Quoted post[/post]
have someone hold the flywheel with a pry bar, then break the pulley nut loose
[post=448469]Quoted post[/post]
bad idea i ahve seen teeth break off
[post=448479]Quoted post[/post]
Originally posted by driverunknown@Jan 20 2005, 09:57 AM
http://www.amazon.com/exec/obidos/tg/detai...476070?v=glance
This one works as well. It is really strong and heavy. I used it on my own engine. It was the cheapest one I found, you just need your own 1/2 inch breaker bar.
[post=448581]Quoted post[/post]