Recent content by 86civic

i have seen a few cars with them coming straight out of the bonnet i know its a bit extreme but it looks and sounds awsome, a real head turner (and burner lol)

IMG_0049 - Copy by CRX Vtec Turbo, on Flickr IMG_0047 by CRX Vtec Turbo, on Flickr IMG_0063 by CRX Vtec Turbo, on Flickr

IMG_0018 - Copy by CRX Vtec Turbo, on Flickr sorry took a while to figure my pics out lol

my bad lol <a href="http://www.flickr.com/photos/64591082@N06/5880825368/" title="IMG_0018 - Copy by CRX Vtec Turbo, on Flickr"><img src="http://farm7.static.flickr.com/6053/5880825368_ffa725483c.jpg" width="500" height="333" alt="IMG_0018 - Copy"></a>

hey all, iv just about got my project finished now an i thought i would show you guys and see what you think so here it is:

thanks alot mate can you recomend a good software to use? my ecu is socketed and im going to buy a chip burner to make my own. thanks again

ok mate cheers can BRE disable it ok?

nobody has any info?

hey all, iv just finished building my crx (B16) turbo and have run into a few problems. first off im running obd0 and dont really have the money to convert to obd1. heres the first problem, the obd0 B16 runs two lambda sensors and the down pipe i have only has previsions for one. i dont mind...

ok mate cheers il take some pics i the morning and post them up thanks again

if im being honest iv got quite a few plugs im not sure where they go but i think most are for aircon abs etc thanks man i think you might have just saved my project :-) one other question, other than the main relay unit and incar fuse box is there another fuse/relay box under the bonnet? i dont...

i can safely say i do not have this box, i take it it is essential? im going to order it straight away if they post to the uk thanks a lot i really hope it works :-)

i have heard about those do you know what they look like or where they are? i havnt tried a new distributor as they cost around £150 and its abit tight at the mo. do you think it worth buying one to try? thanks alot man

im using the original pw0 with standard connections

hey all i have just completed a b16a1 swap into an 86 civic but it wont start :-( i bought the engine, gearbox, full car wiring loom and ECU that came from the doner and it just wont go!. im a mechanic by trade so i know what im doing when it comes to fitting and wiring etc but i dont have that...