Recent content by jOnZ

hows your wheel bearing?

Tested my fuel pump its still good but no power is getting to it. My main relay and all my fuses are still good still cant seem to figure that problem out. As for my starter i tried grounding one of the starter bolts directly to frame still just clicks! :confused:

Wtf? Is this site dead now or what? I really need help on this. I tried main relay and checked all my fuses everything is grounded starter just clicks & fuel pump still will not turn on.

92 civic hatch everything was working fine up until recently my fuel pump doesn't prime and my starter just clicks both at the same time. I checked all my fuses and main relay its all good. My starter is good I've tried different starters my fuel pump was just working as well as the starter now...

Bump

No, its not the switch being on cold. Also my radiator is fine car doesn't over heat stays a little below half.

As the the title says my heat is not working in my 1994 integra LS. I was thinking heater core but if thats not it what else could it be? :confused:

Problem is my turn signals are not working but my hazards do. I've checked the fuse and the fuse is still good they just stopped working randomly. What else should I be checking?

I'm guessing its my valves only thing that dont make sense is the knocking. When I first start it up after its been sitting it will knock but if I shut the car off and start up again it wont knock. could my valves be getting stuck open? Other opinions/suggestions would be great !

Ok, when I first start my car up it knocks then it goes away. It's not rod bearings I dropped the oil pan and checked everything out and replace the bearings anyway. Car is not what it use to be a few days ago ever since i heard this knocking although my valves are EXTREMLY loud. Could the...

Going to be boosting my b18b1(LS) @ 4 pounds low boost I know its capable of more but this is just a start. Will stock injectors & fuel pump be good enough on 57 trim or maybe lil smaller or will i get cut?

Not ecu either :confused::confused: wtf? Lol, this is very odd... I'm lost on this one anymore suggestions?

Tried a new wire harness still not the problem ..... anyone?

Bump no one knows what going on or what?

Ahh, my bad its the other way around z1 block z6 head that lowers sorry. I read wrong :-P