Recent content by rex2nr

and as cool as that could be, it'd never be possible, or reliable. It had the Si motor, but the driveline was just about at its limits. It also was a very crappy designed system

I would say no, we parted a sol out, and the window frames were pretty damn strong, and it will end up weakening the car. The front may be less structural then the back roll bar/window frame tho

can't you just put a bolt in there? I saved my pin, but I've heard you can do that

VTEC is overrated! :P (j/k) Everyone was trying to convince me to do a B16 instead of ZC, but it does work out to be much cheaper to go ZC. since you can use your stock tranny and axles, you cut out buying that, ($350?) you can use your stock ECU, (150ish), stock motor mounts, unless they are...

its the same throttle body off the 88-91 Si, I'm using the USDM one on my ZC since mine was broken in shipping.

I love the new shifter placement, and it is nice how roomy the new Si is, but I was beating my friend in his with my 89 CRX si, which only had an exhaust. I've driven his, but it didn't have that balls out performance that I expected from it, but it was a very comfortable car to drive. I want to...

will this work? I'm not sure if OBD stuff will mean they are compatible or not. I have a D16A6 I'm parting out, these are going into the D15 in the Civic hatch.

I'm doing my ZC swap myself, 730 for the engine, shipped, 25 for a water pump, 25 more for a timing belt, only expenses I've needed due to the swap. I did need a clutch, but I'm not going to count that since it was down to the rivets anyway, and probably had a month or two at best on it. Oh I...

http://www.geocities.com/chipman_13/zc.html

if you are talking about removing the linkage from the tranny, slide the rubber boot back, pop off the clip. You should see a pin that is pressed in. Take a long extension, or 2, place a screwdriver attachment on the end with a philips bit, put this in the pin (its hollow) and beat it out with a...

ZCs use the same mounts, tranny, axls, and your ECU will work, tho its not the best one... :D

threw a rod bearing, tore the bottom end all to hell

I blew my engine with 140k on it :( therefore, a ZC

if you want to autocross, do the suspension... there was a kid near me with an untouchable CX, won every race he was in, stripped interior, rota slipstreams, and suspension, he now has a B18B in it, and is even faster :rolleyes: :D

hey, couldn't find a topic on this, so... What do you guys run with your ZC powered CRXs, and what mods do you have? I'm trying to get an idea what I will be running in two weeks, so I don't go talking too much smack :P <<<EDIT>>> Also, any problems you guys encountered? how long to do? Any...