erm ya but i need a car to drive till the machine shop is done with the pnp and 3 angle job on the h22 head, and i still dont even know what valves to get. Some say skunk2's are only for low comp (i plan to to have an effective comp ratio of 15.1 in the future with the right turbo) some say get...
weee time for port and polish and biger valves and 3angle vavle job:D
any one whnt to suggest a type of vavle. I have heard numerous stories some say go with ariras some say skunk 2. What is the argument the two. or are there better valves that hold up to 10 lbs boost ona a reg basis. i...
i say yes but wtf do i know. i am just a guy that learned his ass off agout these engines and came up with a final result. If i f'd up in any way mods pls lemme know. pls .
Its an h22a autotenshioner went bad. Also did the test at the point in the stroke where none of the valves should be open(both lobes of cam pointing up) and air poured out of the exhuast valves. Started the compressor at like 20 psi and turned it on to see if i could get any compression and got...
Looks like i am going to need a valve spring compressor for replacing my bent valves. Is there any kind that is better than the others? Or should i just pick up one from ebay? I see two kinds there one is an 8 inch auto engine valve compressor and one is
UNIVERSAL OVERHEAD VALVE SPRING...
I just took the shrader valve off my cheap autozone compression tester so it would allow air to enter the piston then hooked it up to the compressor. Easy way to tell if you have bent valves.
Qustion tho i set the piston at tdc for each and then rocked the crank back and forth till i head...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.