It's a 94 GSR that I'm in the middle of putting into my 00 EX Coupe.
I'm having a mess of a time trying to fit the rear T bracket to where it needs to go. From the pic below you can (hopefully) see where the red arrows are pointing at the bolt holes, but the bracket itself seems too long to fit...
Could only find a OBD1 GSR that's local and in my price range. Ideally I would have preferred OBD2, but alas OBD1 is what I ended up with. Haven't done a OBD swap backwards, so going into somewhat uncharted waters for me. Could use some input on if I'm collecting the correct parts. If you...
AC wasn't blowing cold when I turned it on. Had a look under the hood and found this wire had come loose. I can't quite figure out where it should plug back into. Any help as to where it might belong would be helpful. Thanks.
I have 2 problems that I just can't seem to shake. Looking to see if anyone might be able to help beyond what I've read from other posts on the same topics.
1) Car turns over, but won't start. The car has sat for over 2 years. I've checked and cleaned the 3 grounds - Valve cover to driver...
This stuff has been taking up space in my garage FOREVER. Since the demand for SOHC parts is less and less everyday, the cheap stuff I'd likely be willing to give it to you for free if you just pay for shipping.
5th Gen SOHC
VX exhaust manifold - $15
DX exhaust manifold - $15
DX starter - $15...
I took the trip this weekend from Daytona to Atlanta to attend HIN. I thought the show was ok. Nothing really impressive that stood out at me. Anyone else go? Any different impression?
What's the chances the my supposed P30 is actually a P28?
I had the JDM harness on for a while and had the knock sensor hooked up. And I recently went back and installed my USDM DX harness and just wired up vtec. I didnt wire the knock sensor back in to the harness and just left it out. I...
So I'm driving down the strip and I look down at my gauges and there's no light. I pull over and check my taillights, and sure as shit they are out too. I get home and pull the fuse, it's blown.
I grab another 15A fuse and turn my lights on, <poof> it blows too. I checked my bulbs, and I...
In my sig you will see a list of my current mods. I haven't had a chance to dyno and tune to run the nitrous. My eventual goal is 250-275 to the wheels with some boost (not including the juice). I'm hoping to piece together turbo parts over the next 6-8 months. I'm only looking to boost...
For those who missed my original post.... (Read HERE)
I swapped in the DX harness and it ran fine. Now today it started back with the same electrical problems. My fuel pump whines as if I was turning a wheel to generate its power. It whines at about the same rate an A/F guage would when you...
Before I explain the problems I have been having, it might help to explain exactly what my setup is. I purchased a JDM B16 (SIR2) back about 5 months ago. The swap did not come with the shift linkage or axles (though it did come with the intermediate shaft).
I went ahead and dropped the motor...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.