which distributor do i use, or how can i wire it to obd1. Also what kind of ecu do i use because obd0 doesnt plug in. Any other problems i should expect in this 94 eg hatch. thank you
now we all know the y8 is obd2. but is there a way i can make the y8 manifold work because the piping is bigger. there is a plug on the 94 manifold that the y8 doesnt have. any suggestions. can i eliminate the purge valve? thanks alot for you help
matched the marks with the arrows.. still think the timing is wrong. the car starts but sputters and bogs out causing it to stall. wont stay running. any suggestions? also is there a site i can go to to see this timing situation.
i put a vtec head on a 1.5 block. my problem is when i go to turn the crank the timing belt starts to slide off the head and crank pulleys. im currently using the complete 1.5 bottom end including water pump.. etc. the belt tensioner we stripped so i tapped it to a 7/16 standard .. (all i had)...
one minute it works another it doesnt. shut my drivers side door for a second to get out of the car. Now its stuck, i have power options.. no nothing go caught in the door . It just wont open from the inside or outside. Has anyone ran into this problem and possibly have some type of solution...
car was running fine parked it for the night and we had another cold night
went to start the car the next morning and got that fast clickin sound like the battery was dead. Tried to jumpstart it, no power at all to the battery
went out bought a brand new battery and checked all fuses and...
im going to put a zex system in my 00b16a2 motor .Are there certain ways to use nos to not wear the motor as bad? Im sure it needs to be used right including not using it in the red zone.
i bought a 00 b16a2/obd2 swap off a buddy of mine, funny feeling tells me he just gave me a distributor to sell the motor. Hes shady like that. The one i have now has one of the three arms cut off to make it fit. Which dizzy can i use that will bolt right up? ? thanks for the help.
started the motor tonight , thanks to a buddy of mine Thanks Cory! i do have an eratic idle though.. i believe its the tps sensor . Will replace and update.
What wires need to be ran ? I currently have a 0bd1 p72 which may be running the motor for alittle bit. I am getting the p30 later. Also what needs to be ran for Knock sensor? and where is it located? My car is an ex so im already ran for vtec. Any help ?
I have hoses from the charcoal canister that have no where to go.
Also there is a sensor on top of my fuel rail. Are there any available diagrams out there? I would take pics but the digital is dead.
i swapped a 00 b16 into my 93 civic ex. i tryed to use the hoses from my stock radiator. they are to small. I heard i use hoses from a del sol? Any help would be appreciated.
please email me with what you have available. I am in need of a b18a,b18b motor swap complete. no crazy prices. thanks for you help
im at aol: slammedb18acivic email: mike_18337@hotmail.com
i have a a d16z6 sohc vtec with a polished head,jdm camshaft,jdm pistons and rods . Is this wrth buying for an everyday driver in a 93 civic ex or just go ls ,gsr,b16
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.