Search results for query: *

You can swap the heads.....but why? If you get a b20 with a b20 head, then why would you swap it for an LS. Besides like I said before, the LS's head is only 81mm wide in the combustion chamber to match the block. While the B20 is 84mm in the combustion chamber. The only time you need to...

Ok, Dont listen to mwasnp, All you need to do when you get the b20 is like the first guy said is to swap the Intake for the LS one. Keep the LS throttle body and all of the sensors. Dont swap the Heads.....LS is a 81mm piston and the b20 is a 84mm piston... Other than that the whole setup...

I finally got them yesterday. Also if you read the ad....it said to email for them. Anyways, you can find some at this link. I have more if your truely interested. http://www.geocities.com/fxcustumz/IMPORTPIX.html

1994 Acura Integra GSR: Fully Built B18c: balanced knife edged Crank Eagle Rods Wiesco Pistons 8.5/1 CR Ported head JG Intake Ported Throttle body 64mm New Radiator A/C blows cold Tanabe full Cat Back jdm Type R Tranney with LSD Clutch Masters 7lb. Flywheel ACT stage 2 clutch Exterior: Shaved...

If you have apexi afc or vafc then you can make it up if there is any difference. I am using the stock one off the car and it runs fine without an afc. You dont have to use the LS, its just nice to keep it all LS, if you know what I mean. Hybrid Axles are axles like 91 integra inners and...

We are currently doing a B20 in a Civic DX which is the exact same as a B18a or b as far as outer demensions and sensors go. You just use the intake, Throttle body and header from a B18A. The only other difference between the two is internal's. Which means more torque and more horsepower...

I run a Tanabe ( I think that is how you spell it) catback exhaust and it sounds very deep. The thing I would look for is to make sure that where the mid pipe bolts to the muffler back by the rear spindle, that it does not get small. Almost all of the cat backs I have seen are like 2 1/4"...

What ever you all do dont listen to pissedoffsol He obviously has never turned a wrench on a honda and should not be allowed to give advise on something he knows nothing about. You can pretty much take any honda distributor and place it on any honda motor. I have put obd1 d15 distributors on...