Search results for query: *

Looks like i am going to need a valve spring compressor for replacing my bent valves. Is there any kind that is better than the others? Or should i just pick up one from ebay? I see two kinds there one is an 8 inch auto engine valve compressor and one is UNIVERSAL OVERHEAD VALVE SPRING...

I just took the shrader valve off my cheap autozone compression tester so it would allow air to enter the piston then hooked it up to the compressor. Easy way to tell if you have bent valves. Qustion tho i set the piston at tdc for each and then rocked the crank back and forth till i head...

I dont know if anyone here has seen this yet so i figured i would put it up here. ...Michelin Tweel is the fusion of the tire and the wheel with the potential to transform mobility. Available now for lower-speed, lower-weight carrying vehicles, Tweel is in the prototype stage for passenger car...

Hi everyone, i was wondering if i should bother making or buying some type of tool to screw the piston back in. I have a six inch c clamp hehe but that didnt really work too good , then i looked on here and found out that i need that screw tool. So should i just rig something up to apply...

Does anyone know tha widest wheel that can go on the front of a bb4 prelude? Will i have to cut the fender to go over 7.5? I was thinkin about 9.5's front 8.5's rear.

Hey ppl. I'm doing a h23/95 prelude si to JDM h22 swap and had a few last minute questions about wiring. First, where is the extra a/c fan switch located on the usdm engine that i have to put on the jdm. Second, how do i get an internal coil distributer cap for the h22, i heard that i can use...

Ok i'm no mechanic so i never heard the word dizzy before. Why do ppl call it that, and what is it? I assume that its the distrubuter but is it a particular part of the distributer or what?!?

Does anyone know how to install the vtec tach guages? Its probably really easy but i dont know much about wiring these so a lil help would be great. It came with what looks like a lil relay and the actual gauge viewing surface(clear sheet of plastic)

the jdm h22a i got has a backwards harness aka it runs to the driver side instead of the passenger like i need. so can i run it the other way or am i screwed?

i need acc belts for aem underdrive pulleys anyone know part# or mfg for h22a

i just got an h22a from japan and it looks all nice and shiny which rocks but it wont go to easily into my 95 prelude s very well if it obd2 :cry: so how to tell if its obd1 or 2? also where can i find the production date on the engine? thnx ppl

just wondering if i can get the axles off and on again during my swap w/o a ball joint separator and compressor. i dont wanna buy them :mrgreen:

yo ppl i was just wondering what parts i need to do the tenshioner fix and where to get them. Engine is an JDM h22a. I need to know what to do with them as well. much thanks in advance

yO anyone know where to get a diagnostic scanner for an odb1 prelude h22a for around 30$ or less? looked on ebay but can only find odb2

Hey peeps i'm posting to find out where to get torque specs and other relavent tech info for my swap. I'm putting a JDM h22a obd1 into a 95 prelude that had an h23 in it.