Search results for query: *

A good friend of mine is looking at buying a 96 gsr. Here's the catch. It's got a b16a1, running on an ls wiring harness and ls ecu. Tach doesn't work because of the harness, nor does vtec. Aside from changing the ecu, what else needs to be done to get this beast running properly? Thanks in...

The car came stock with VTEC. The stock head was a B1 as well. Also, please disregard what I said before... It did not jump time. I found that the cel is on because of an EGR valve or solenoid issue, which happened because we unplugged the wire to the sensor while it was running. I reset the...

a friend of mine jacked up his head. it's a 95 accord ex f22b1. he replaced the head, timed it, and test drove it. it jumped time. we fixed the timing, and got it "running." it runs rough, rich, and throws a cel. did the jumper trick, got 3 short blinks and 2 long blinks. looked around, and...

Found out that the intermediate shaft bracket isn't hooked up, does anyone think that that might cause the slow rev? it also jerks really badly, which could easily be explained by that.

We've swapped in a new ls motor, sleeved, bored to 84mm, 9.1:1 pistons, and crower rods. Problem #1- The person who built the motor stripped the oil pan nuts. It's an obx oil pan, and was wondering if it's best to put new nuts on, or new studs, or remove the studs and go with all bolts...

i helped my roommate put a 50trim t3 on his integra, full boost before 4 grand, and he got his for like 300.

are the plugs, wires, and dizzy good?

my other concern was motor mounts, mine are doing a fine job, do you think i'll have to change them to hold the new motor?

My Prelude is a 92 with an h23. I want to swap in the h22, but plan to keep my tranny. it's a 5spd, other than the motor and head, what else do i need to change? and can i get away with chipping my ecu and running an h22 map on the chip? thanks.