Search results for query: *

I got a 91 crx w/ DOHC ZC. Recently, after the car has been running at full temp for a few minutes, the temperature gauge needle starts to go crazy. It'll bob up and down sparatically, and also dip in direct relation to the gas pedal. I can stop at a red light and the needle will rise back to...

I have a 91 HF CRX, it had a lame ass camber kit that replaced the stock front upper control arm bushings. Im trying to switch back to the original setup so I ordered some OEM bushings online. My question is: Is there supposed to be spacers that go on either side of the bushing? Like over the...

I have a 91 HF CRX. It's lowered and I was told it had a camber kit installed. I took it too an alignment shop cuz the camber was horrible. The guy said "you need a camber kit, I've done all I can do". And let me tell ya, the camber is visibly off, a lot. So to save money I bought a Revo...

Before everyone badgers me for not searching other posts, believe me I have. Ive found some useful info, but my circumstances are a little weird . I just did a Dohc Zc swap in my 91 HF CRX, went well except after the fact the transmission sucked. The engine drove and idled great. I then parked...

what the hell is the name for the threaded studs that come through the hub for your lugnuts to tighten down on? How do you change them? Mine are too short, with the rims I got, the lugnuts only have to enought thread to go about 2/3 the way on. Sketchy. From attempts to remove them, there is no...

Im about to do my first tranny swap. I have a 91 HF CRX with a DOHC ZC, L3 transmission (Si). Whats the best way to do it (as in fastest, least painful way), pull the engine and do it outside of the engine bay or do it with the engine in the car? All my buddies say pull the engine, but all the...

I just swapped a dohc zc in my 91 hf crx. Everything went well except 2nd gear grinds really bad. Im pretty sure its an si tranny. I got the motor, the tranny, the axles and the hubs for 300 bucks. I told the guy, "hey man i got another si tranny if this one is shot, so if it needs to be changed...

I have a 91 HF, my SOHC ZC took a crap on me so I dropped in a DOHC ZC. Everything went well, considering it was my first swap. I switched my connectors for the distributor and ran the two extra wires to the CPS. Hooked everything thing up and coulda swear everything was right. Went to start the...