1994 Honda Civic Hatch B16A2 5spd $2900

We may earn a small commission from affiliate links and paid advertisements. Terms

Status
Not open for further replies.

bakerderek0

Up a Creek...
Up for sale is my EG Hatch:

civic3u.jpg

By topnotchhandyman, shot with DSC-W55 at 2010-04-04

civic2oi.jpg

By topnotchhandyman, shot with DSC-W55 at 2010-04-04

civic1q.jpg

By topnotchhandyman, shot with DSC-W55 at 2010-04-04

I've recently done:
*New Head Gasket
*New Spark Plugs & NGK Wires
*New Dizzy Cap & Rotor
*Coolant Flush
*Camshaft Seal Replacement
*Valve Cover Gasket replace
*Valve Adjustment
*New PCV Valve
*New Throttle Body Gasket

Here's the EXACT list of mods I was given when I bought the car a year ago:

motor
b16a1
compressions raised 12-11.8
type-r springs
type-r motion assembly
port n polished head
3 angle valve job
bored 20 over
ctr forged pistons
acl bearings
ITR tranny
b&m short shifter
new bushings and gears
gsr front boots
cermaic gears
Limited slip Differential
gsr anti roll bars
exedy stage 6 unsprung clutch
ltw flywheel
tananabe exhaust
suspension
ground control coilovers
carbing 3-piece strut bar
integra ls wheels
exterior
painted pheonix yellow
spoon mirrors
interior
SI interior
wired for a system(dont know why)
carbon fiber gauge bezel
battery relocated to trunk


I'm not a good tuner. I just want this thing gone! It has an idle issue that I cannot figure out.Here's a post I started a while back when I got this car: https://hondaswap.com/general-tech-maintenance/car-dies-after-short-vtec-run-421605/

The price of $2900 is firm, don't waste my time or yours with lower bids. I will accept a 1979 or 1980 camaro as trade.
 
wow, i would snatch that up in an instant if i needed a car.

free bump.
 
That's not rust on the headers right?
You think you could post some interior pictures,
and a close up under the hood :D
That would be nice...
 
That's not rust on the headers right?
You think you could post some interior pictures,
and a close up under the hood :D
That would be nice...

Thats a stock exhaust manifold cast and yes it will rust but is completely operational and fine.
 
That's not rust on the headers right?
You think you could post some interior pictures,
and a close up under the hood :D
That would be nice...

Sure, I can post some closer pics soon. I've actually caught myself trying to fix the car's issues again, so I'll put some up when I get a chance. I've got a new dizzy ordered in an attempt to fix the lack of power.
 
i actually had a similar problem in my ek...I never performed a swap, but I put some injector cleaner in, fixed the rough idle for the most part, as for the shutting off after vtec I researched and found for those years honda has a recall on ignitions...needless to say took it to a friend of mine's shop, forget exactly what part it was, but it fixed it right up, but it was definitely the ignition
 
I've been told that my problem is related to the stock ecu and a 12:1 compression ratio. I plan to take the car to a performance shop in suwanee as soon as I can get my hands on a trailer. Once I get the ecu tuned, we should be ready to sell!
 
$2900 is the price as of now. Once the power loss issue is resolved, I will ask for more. So if you want it for $2900, get it now.
 
lol, if I were going to get it, I'd have to have it running fine first... haha if I flew down, I wouldn't want to get stranded on the long trip back to Michigan...
-not that it's a bad idea to let people know they can buy it before the problem gets fixed...
 
edited post above states the car was sold.

locking it up.
if its infact not sold, please pm me and i will unlock.
 
Status
Not open for further replies.
Back
Top