bakerderek0
Up a Creek...
Up for sale is my EG Hatch:
By topnotchhandyman, shot with DSC-W55 at 2010-04-04
By topnotchhandyman, shot with DSC-W55 at 2010-04-04
By topnotchhandyman, shot with DSC-W55 at 2010-04-04
I've recently done:
*New Head Gasket
*New Spark Plugs & NGK Wires
*New Dizzy Cap & Rotor
*Coolant Flush
*Camshaft Seal Replacement
*Valve Cover Gasket replace
*Valve Adjustment
*New PCV Valve
*New Throttle Body Gasket
Here's the EXACT list of mods I was given when I bought the car a year ago:
motor
b16a1
compressions raised 12-11.8
type-r springs
type-r motion assembly
port n polished head
3 angle valve job
bored 20 over
ctr forged pistons
acl bearings
ITR tranny
b&m short shifter
new bushings and gears
gsr front boots
cermaic gears
Limited slip Differential
gsr anti roll bars
exedy stage 6 unsprung clutch
ltw flywheel
tananabe exhaust
suspension
ground control coilovers
carbing 3-piece strut bar
integra ls wheels
exterior
painted pheonix yellow
spoon mirrors
interior
SI interior
wired for a system(dont know why)
carbon fiber gauge bezel
battery relocated to trunk
I'm not a good tuner. I just want this thing gone! It has an idle issue that I cannot figure out.Here's a post I started a while back when I got this car: https://hondaswap.com/general-tech-maintenance/car-dies-after-short-vtec-run-421605/
The price of $2900 is firm, don't waste my time or yours with lower bids. I will accept a 1979 or 1980 camaro as trade.
By topnotchhandyman, shot with DSC-W55 at 2010-04-04
By topnotchhandyman, shot with DSC-W55 at 2010-04-04
By topnotchhandyman, shot with DSC-W55 at 2010-04-04
I've recently done:
*New Head Gasket
*New Spark Plugs & NGK Wires
*New Dizzy Cap & Rotor
*Coolant Flush
*Camshaft Seal Replacement
*Valve Cover Gasket replace
*Valve Adjustment
*New PCV Valve
*New Throttle Body Gasket
Here's the EXACT list of mods I was given when I bought the car a year ago:
motor
b16a1
compressions raised 12-11.8
type-r springs
type-r motion assembly
port n polished head
3 angle valve job
bored 20 over
ctr forged pistons
acl bearings
ITR tranny
b&m short shifter
new bushings and gears
gsr front boots
cermaic gears
Limited slip Differential
gsr anti roll bars
exedy stage 6 unsprung clutch
ltw flywheel
tananabe exhaust
suspension
ground control coilovers
carbing 3-piece strut bar
integra ls wheels
exterior
painted pheonix yellow
spoon mirrors
interior
SI interior
wired for a system(dont know why)
carbon fiber gauge bezel
battery relocated to trunk
I'm not a good tuner. I just want this thing gone! It has an idle issue that I cannot figure out.Here's a post I started a while back when I got this car: https://hondaswap.com/general-tech-maintenance/car-dies-after-short-vtec-run-421605/
The price of $2900 is firm, don't waste my time or yours with lower bids. I will accept a 1979 or 1980 camaro as trade.