Ok, well i finally finished my b16 swap into my da. Two problems i'm having are 1. I went to wire my vtec and realized that the vtec solenoid doesn't have an oil pressure switch on it, just the one wire for the solenoid. Isn't there supposed to be an oilpressure sensor there too? there isn't even a place to put one. where it would go there is whole, but there is no threads or anything. I'm lost with this. and 2.when i first start up the car, the motor revs up to like 1500 till it gets warmer, then it will idle at like 1000 but go up and down between 750 and 1500. when i first take the car out after starting it will usually stall the first time i come to a stop, then after i've been driving it will idle fine some times and other times will jump up and down again.
I'm kindof new to the swap thing so any help would be greatly appreciated. My check engine light is on, but i don't know how to check the code, so if someone could fill me in on that too it would be great.
I'm running a p30 ecu by the way. I used the stock harness that was in the car and would just like to run the wires and pin the ecu for the vtec. the car is a 93 integra and had a b18a1 in it.
Please guys help me out.
i have a lot of other things done to the motor as well, if you want to check it out go to www.hondasutra.com and check out the project page.
here is a pic
I'm kindof new to the swap thing so any help would be greatly appreciated. My check engine light is on, but i don't know how to check the code, so if someone could fill me in on that too it would be great.
I'm running a p30 ecu by the way. I used the stock harness that was in the car and would just like to run the wires and pin the ecu for the vtec. the car is a 93 integra and had a b18a1 in it.
Please guys help me out.
i have a lot of other things done to the motor as well, if you want to check it out go to www.hondasutra.com and check out the project page.
here is a pic