Uppertorso
Senior Member
I have a 1990 civic DX with a B16a JDM engine/transaxle swap. I just installed new axles on the vehicle. The passenger side shaft is ok, but the shaft on the drivers side seems to be too long???? I ordered shafts for a 1990 integra. So when the vehicle is going into a corner to the right (weight shifting to the left causing the axle to compress) there is grinding noises coming from the left front axle shaft. When installing the shaft it was a little tighter than normal to get the ball joint in. Therefore it seems that the shaft is too long. Has anyone run into this problem or have any suggestions???
any help would be appreciated, thanks in advance.
any help would be appreciated, thanks in advance.