B18 into EJ6 issues identify these sensors/plugs!

[arf4n]

obd2b car and put in a b18, ive used the obd2b ek4 loom with a chipped p28.

I thought this would all plug and play but i have some problems...

The car seems like it doesnt want to run?! it barley idles and around 1.5k the revs bounce until i give it some more gas and will rev upto 4k

its throwing up ecu codes;

6 Engine coolant temperature
10 Intake air temperature sensor
14 Idle air control valve or bad ECM
22 V-TEC pressure solenoid

messed around / cleaned all of these and still the same?

also i have these sensors/plugs left over..

What is this plug for?

which one is the engine coolant temp?

Do i have two Intake air temperature sensors? one on inlet runner and one in induction pipe?

I will be grateful for any help!

 

[EKB18B1]

hey man are u using d16y7 or y8 harness? also not sure why but we're kinda having the same issue...we swapped the b18b into my ek hatch and it threw few codes we worked them all out and now i got no cel but it wont rev over 3500... if u figure it out lmk

 

[EKB18B1]

oh also we just used iat on the intake not on the runners