Sofa King Slow
Member
I need main bearing tolerances, torque for main caps, rod bearings, front main, and rear main caps. I can't afford to buy a Helms' manual yet, nor can I afford to just tighten until my elbow clicks. Thanks for your help.
We may earn a small commission from affiliate links and paid advertisements. Terms
Originally posted by reckedracing@Apr 12 2005, 04:34 PM
you must be challenged
you think they make this shit up???
you think the people at auto zone rip down motors and figure out tolerances???
auto zone does retail auto parts... RETAIL...
they do not make the books, write the books, or even READ the books... they just sell em...
[post=486273]Quoted post[/post]
Originally posted by reckedracing+Apr 12 2005, 04:41 PM-->Sofa King Slow@Apr 12 2005, 04:14 PMwhat in the holy fuck are you talking about?
[post=486281]Quoted post[/post]
Because these measurements can determine whether or not I have to rebuild this engine, I would rather rely on information from Honda's actual engine manual. I just can't get past the guy at the desk to steal one from their service department.
[post=486252]Quoted post[/post]