ok, here's the deal. I did an engine transplant in a 97 civic DX 2dr. put 
in a 98 D16Y8. got the ECU but not the harness, so I ran the VTEC wires
seperate. It turns over great, but won't start at all. Got new plugs and
wires, but the plugs were bought for the non-vtec motor. also, the sensor
that's on the backside of the intake manifold(3 wires, close to the TB
side) isn't hooked up and we don't have any of the O2 sensors hooked
up(actually no there at all) I didn't think any of that would cause the
car to NOT start, just maybe run rough, but I don't know. Any help is appreciated
	
		
			
		
		
	
				
			in a 98 D16Y8. got the ECU but not the harness, so I ran the VTEC wires
seperate. It turns over great, but won't start at all. Got new plugs and
wires, but the plugs were bought for the non-vtec motor. also, the sensor
that's on the backside of the intake manifold(3 wires, close to the TB
side) isn't hooked up and we don't have any of the O2 sensors hooked
up(actually no there at all) I didn't think any of that would cause the
car to NOT start, just maybe run rough, but I don't know. Any help is appreciated
 
	 
 
		 
 
		 
 
		