I am stuck on a part of my build I am trying to put on the timing pulley and it does not make sense to me. I posted this question in my build thread, but there might be a better chance of getting it answered here. Here is a pic of what it is supposed to look like according to the helms manual...
And here is what mine looks like...
Notice the flared end on my pic. The line for tdc is on the side shown, but when I looked up the parts on majestics website they show this type of setup as well as the one seen in the helms.
If you look at the pic above you can see that the pulley is facing the opposite way than mine is, but that would cause the tdc line to face the wrong way. Also I only have one of the washers, not two like shown in the helms. Any help would be greatly appreciated.
And here is what mine looks like...
Notice the flared end on my pic. The line for tdc is on the side shown, but when I looked up the parts on majestics website they show this type of setup as well as the one seen in the helms.
If you look at the pic above you can see that the pulley is facing the opposite way than mine is, but that would cause the tdc line to face the wrong way. Also I only have one of the washers, not two like shown in the helms. Any help would be greatly appreciated.