i got my gsr manifold by aebs, and it looks ok. my one question is, is it all right to use a dremel to remove the casting marks on the inside of the runners?
Originally posted by fakthepolice@Jun 15 2005, 02:25 PM i got my gsr manifold by aebs, and it looks ok. my one question is, is it all right to use a dremel to remove the casting marks on the inside of the runners?
Because there's a couplea coolant lines attached to the intake manifold, and it's better to drain the coolant from the radiator plug into a pan than spray coolant all over your engine bay when you disconnect the coolant lines on the manifold.
I didn't know AEBS made an intake manifold for a GSR, I knew they made them for the B16 and the B18C5 but I didn't know that. Where did you get yours from?
I just went to the AEBS site and here is the link that specifically says that they do NOT fit the GSR head. If you have one let me know where you got it.
Originally posted by integraslut78@Jun 21 2005, 08:08 PM I just went to the AEBS site and here is the link that specifically says that they do NOT fit the GSR head. If you have one let me know where you got it.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.