Mount suggestions

[FyReo3]

Can anyone point me in a direction to find aftermarket mounts for a B18c1 in a 6th gen?

 

[JDMilan]

try a search via google

I would suggest either using the hasport or placeracing mounts.

 

[xj0hnx]

Or just use the stock mounts.

 

[FyReo3]

I checked the Hasport site, they do not have them for my car..... 99 EX. They have them for an H22 swap and a few others, but not B18c1.

 

[GSRCRXsi]

hasport calls them "replacement" mounts

 

[xj0hnx]

Originally posted by GSRCRXsi@Nov 20 2003, 11:54 PM
hasport calls them "replacement" mounts

Exactly, because you can use them to "replace" the STOCK mounts, which work MORE than adequately.

 

[FyReo3]

Gotcha....

This being my first swap, excuse my nooby questions.

Are the "Replacement" mounts fro Hasport stronger than stock mounts?

I just do not want to spend the money on factory strength mounts, only to replace them later. I have big plans for this motor, and I have already been through mounts on my D16.

Thanks for replies.

 

[E_SolSi]

they are solid polyurethane
i have them

the engine wont move at all
the car will vibrate like an epileptic

 

[citrEK]

Originally posted by E_SolSi@Nov 22 2003, 06:52 AM
they are solid polyurethane
i have them

the engine wont move at all
the car will vibrate like an epileptic

^^^ i'm w/ the penguin

i have a 99 DX HB w/ B18C5... used stock mounts, cept for the rear trans "T" mount and driver side a/c mount, i think... i don't remember... stock is good for me...

 

[toyarmy]

if you wanna spend the money on the mounts, go for it. but you should be able to get some polyurethane inserts for your stock mounts for around 30-50 dollars and theyll get the job done nicely.

 

[FyReo3]

Thanks for all the suggestions. I have inserts on my D16 right now, and I must admit they do fine. I just did not know about putting them on this motor. I just wanted to make sure I did not do anything half-assed, that I would have to fix later.


I plan on building this motor before dropping it in, I know everyone has there opinions. What do you think I should go with pistons, rods, and sleeves? Particularly sleeves, for I have never delt with them before. I plan on eventually pushing 15-20 psi.

 

[JDMilan]

a problem that I always had was that my upper right motor mount would bust, but then again I was using the bare amount of just 3 "upper tranny, rear, and upper motor"


the lower tranny and Ac mounts are optional but honestly after breaking mounts I would use them also.

 

[hybrid89]

 

[EJdmB18C]

WERD!