NO START 90 accord motor swap

[FTPRACING]

1990 accord lx 5spd f23 swap 25K

p28 ecu burned

Motor has fuel rail with 440cc on resister, runs on 94 oct

Problem car does not start, turns over and over, does not sound like its firing

it does have spark and is getting fuel, timing should be right

new parts:
fpr
fuel lines
main relay
rail
injectors
resistor
distributor
plugs
wires

Any ideas on what to check or what u may think is wrong? please input

 

[tab]

I would double check that the injectors are pulsing. You could have fuel at the rail with no fuel being injected.

Recheck your firing order possibly.

Just suggestions.

 

[FTPRACING]

Originally posted by tab@Mar 9 2005, 03:00 AM
I would double check that the injectors are pulsing. You could have fuel at the rail with no fuel being injected.

Recheck your firing order possibly.

Just suggestions.

[post=471036]Quoted post[/post]​

was thinking pulse but dont have a meter. order was wrong but i think i have it fixed now but hard to find diagrams for the distributer order for the accords

 

[tab]

Originally posted by FTPRACING+Mar 9 2005, 03:38 AM-->

tab

@Mar 9 2005, 03:00 AM
I would double check that the injectors are pulsing.  You could have fuel at the rail with no fuel being injected.

Recheck your firing order possibly.

Just suggestions.

[post=471036]Quoted post[/post]​

was thinking pulse but dont have a meter. order was wrong but i think i have it fixed now but hard to find diagrams for the distributer order for the accords

[post=471042]Quoted post[/post]​

1-3-4-2 going clockwise. #1 usually has a mark on the cap in the form of a number or letter. If not, put the engine at #1 top dead center and look where the rotor is pointing. That's #1.

For the pulse, I'd probably check a manual. I imagine that there is a common wire among all of the injectors, and a trigger wire. Either way, it shouldn't be that hard to check. A decent multimeter doesn't cost much.