not a bad OC i think. took a lot of tinkering and temps are still higer than i like (~71C in prime95, ~63C when folding.
Machine:
Antec 900
q6600 G0
Asus P5K3 Deluxe
2x1GB G.Skill DDR3-1066
Cooler Master Xtreme 550W
zalman 9700NT performance mode (1300-2800rpm)
2x 120mm tri-cool front fans (low)
1x 200mm tri-cool top fan (high)
1x 120mm side fan (1400 rpm)
1x 120mm scithe rear fan (1200rpm)
any recommendations on what i can do to get this stable with a LOWER vcore? temps are pretty high and id like to get them under 70C which priming. i dont know what to do with the other settings, they are pretty much maxed out.
Machine:
Antec 900
q6600 G0
Asus P5K3 Deluxe
2x1GB G.Skill DDR3-1066
Cooler Master Xtreme 550W
zalman 9700NT performance mode (1300-2800rpm)
2x 120mm tri-cool front fans (low)
1x 200mm tri-cool top fan (high)
1x 120mm side fan (1400 rpm)
1x 120mm scithe rear fan (1200rpm)
Code:
CPU Ratio [9]
FSB Frequency [400]
DRAM Frequency [DDR3-800MHz]
DRAM Timing Control [Auto]
DRAM Command Rate [Auto]
DRAM Static Read Control [Auto]
DRAM Dynamic Write Control [Auto]
Transaction Booster [Auto]
Clock-Overcharging Mode [1000mV]
CPU Spread Spectrum [Disable]
PCIE Spread Spectrum [Disable]
CPU Voltage [1.5125V]
CPU Reference Voltage [.63x]
CPU Voltage Damper [Enable]
CPU PLL Voltage [1.60V]
DRAM Valtage [Auto]
FSB Termination Voltage [1.50V]
North Bridge Voltage [1.70V]
North Bridge Ref. Voltage [.67x]
South Bridge Voltage [Auto]
any recommendations on what i can do to get this stable with a LOWER vcore? temps are pretty high and id like to get them under 70C which priming. i dont know what to do with the other settings, they are pretty much maxed out.
Last edited: