EP3Hatch1987 Meeeeooowww!!!!! Jun 1, 2009 #1 Does anybody know how I would be able 2 test my vtec solenoid 2 see if it's working?
AHHVTEC Well-Known Member VIP Jun 1, 2009 #2 run a wire from it straight to the battery, just tap the wire to the hot post and see if its clicking
run a wire from it straight to the battery, just tap the wire to the hot post and see if its clicking
EP3Hatch1987 Meeeeooowww!!!!! Jun 3, 2009 #3 Okay I did it.. It clicked.. So if it's not hitting when I drive would it be wiring?
AHHVTEC Well-Known Member VIP Jun 3, 2009 #4 well it could be a few different things. are you throwing any check engine lights. ? and check your oil level
well it could be a few different things. are you throwing any check engine lights. ? and check your oil level
EP3Hatch1987 Meeeeooowww!!!!! Jun 3, 2009 #5 It was throwing a pressure sensor code when I got it tuned.. And the oil levels are fine..
AHHVTEC Well-Known Member VIP Jun 3, 2009 #8 then it should be working if the code was fixed. what motor is it some sohc motors you cant hear or feel
then it should be working if the code was fixed. what motor is it some sohc motors you cant hear or feel
EP3Hatch1987 Meeeeooowww!!!!! Jun 3, 2009 #11 Okay I might juss go buy a new oil switch.. And do you know the wiring diagram 2 wire in the vtec? Cause I had 2 wire mine in cause it's a dx model
Okay I might juss go buy a new oil switch.. And do you know the wiring diagram 2 wire in the vtec? Cause I had 2 wire mine in cause it's a dx model
AHHVTEC Well-Known Member VIP Jun 3, 2009 #12 as long as its to the right pin on the ecu it will be fine, search for the ecu pin out that your using
as long as its to the right pin on the ecu it will be fine, search for the ecu pin out that your using