I just did mine today and I do 0.006 for intake and 0.007 for exhaust on my B16A But you did not state if it was a B18C or a B18A/B
If its a B18C....you specs for intake side are too tight. Not sure on the Non-VTEC B series heads. I think they are like mine but I could be wrong. I read a googled page that had the specs you refer to but it was for a B18A....not sure though. I know my B16A is the same specs as a B18C for sure.
its the B18B.. i googled mine too and found three diff specs.. The helms manuall had the one listed above,, chilton had the ones listed that you mentioned and clubintegra had a link for specs for 0.005IN, 0.009 EX. Ive never seen a spread like the last one so im elliminating that
My Helm says your spec's too. So you were right! At least I always trust my helm manual. and its was isentical to your numbers. It was a spec sheet with the listing for a B18B1 (USDM)
Need to upload them to a photo share web site then get their URL (I think...its one of the possible links to copy) and paste it here. Try the URL one and preview it.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.