Hybrid93Hatch
Member
This is about the only thing I have NO idea about with my swap.
I have the vtec solenoid, vtec oil pressure, and knock sensor all wired at the shock tower engine harness all neat and $hit!
I looked through the electrical part in my GSR helms manual and I can not find find the pin ID's for the shock tower harnesses for the IAB.
The IAB plug is shown in the pic but it's going to be pretty hard to tap in under the manifold. Where do you guys tap in for this wire to run back to the ECU (A17)
When I unwrapped my Cx wire harnesses wires are spliced underneath the loom / electrical tape. At some points different color wires would spice in and come out to one wire a totally different color :hammer: Has anyone ever traced the IAB wires back to the shock tower harnesses? If not, where is the best place to tap in to this and run it back to the ECU?
There are 2 wires on the IAB above. A reb / blue wire and a black wire that is hard to see. Does it matter which one you tap into? Is the black a ground?
Thanks!
I have the vtec solenoid, vtec oil pressure, and knock sensor all wired at the shock tower engine harness all neat and $hit!
I looked through the electrical part in my GSR helms manual and I can not find find the pin ID's for the shock tower harnesses for the IAB.
The IAB plug is shown in the pic but it's going to be pretty hard to tap in under the manifold. Where do you guys tap in for this wire to run back to the ECU (A17)
When I unwrapped my Cx wire harnesses wires are spliced underneath the loom / electrical tape. At some points different color wires would spice in and come out to one wire a totally different color :hammer: Has anyone ever traced the IAB wires back to the shock tower harnesses? If not, where is the best place to tap in to this and run it back to the ECU?
There are 2 wires on the IAB above. A reb / blue wire and a black wire that is hard to see. Does it matter which one you tap into? Is the black a ground?
Thanks!