MaaseyRacer
Senior Member
Alright here is my set up right now. I just finished porting out my b16 head, I put a lot of hours in on this thing, and I am pretty happy with the way it came out. At the moment my bottom end is a stock B16 bottom end with the 10.2:1 compression, however I eventually plan to put CTR pistons or something with a similar compression. I have been reading a lot of good stuff about these Buddy Club spec III cams and I have decided to buy them from jhpusa.com. My question is; is the skunk2 valve train a good valve train to run with these cams? Is there a better valve train that is more suited for these cams? Is the Portflow valvetrain a good set up? I am going to keep my stock valves so it is just going to be springs and retainers that are going to be changed out. Thanks, any help or information on this set up will be super helpful.
More info on the buddy club spec III cams:
http://honda-tech.com/zerothread?id=795645
More info on the buddy club spec III cams:
http://honda-tech.com/zerothread?id=795645